A new machine never goes straight to the production environment after it has been built. There is still a whole procedure to optimize the machine before you can use it. What does all that mean?
A new machine or part starts with a concept and is then built on the basis of a design. But no machine or part is immediately ready for use.
There are still tests to be done, parameters to be set, performance to be improved, operators to be trained... That is precisely why we consider the implementation phase so important.
The different steps during an implementation
Functional tests
When a machine or part is ready, we first perform a number of functional tests: does the machine do what it is supposed to do, does everything run as it should, does everything meet the safety requirements, etc.
Optimisation
Once the functional tests are complete, we will take a detailed look at the efficiency and operation of the machine or part. We optimize where possible to achieve maximum performance.
Parameters
We set all parameters correctly so that the machine can function perfectly. This is usually done in consultation with the operators who will operate the machine on a daily basis.
Training
Before the machine is put into use on the shop floor, we will educate and train the operators. In this phase they get to know the machine in detail.
Installation
We install the machine on the production floor and test it within the production chain. If necessary, we do the last optimisations.
Support
Once the machine is up and running on the production floor, we are still available for questions, advice, support or adjustments.
Do you have any questions about the implementation process?
Let us know and send us a message. We'll do our best to come up with an answer to your question.
When we build a machine, we make sure that it perfectly meets your expectations. This goes beyond the purely functional operation. We ensure the highest possible performance and return, provide training and support for your operators and come and install the machine on your production floor.
Afterwards, we remain available for questions, advice, support and adjustments. This way you can be sure that the machine you need does exactly what you expect it to do.
We can do this nationally and internationally (especially in the United States).
What makes Absolem different?
Customised solutions: A specific engineer for a specific project or timeframe? A tailor-made solution from our own engineering center? Engineering consultancy or advice? Everything is possible.
Extensive expertise: How about 60+ engineers, all with their own knowledge and experience? This collected expertise is completely at your disposal.
Maximum service: Our motto is simple: "there is no traffic jam along the extra mile". We do everything possible to provide you with the best solution for your challenge.
Laser technology: We have the largest independent laser lab in Europe.
People-oriented and sustainable: A high-tech engineering company that still puts employees, customers and partners first? Check. Sustainability? We put our money where our mouth is.
.png?width=300&name=Vlinder%20+%20woordlogo-min(1).png "Vlinder + woordlogo-min(1)")
